700R4 Transmissions have 3
Speed-o-meter Gear Types: Compare the three photos to the gear set on your
original transmission.
1) VSS = Vehicle Speed Sensor
VSS Drive Gear can be removed.
Place punch behind metal gear and
drive gear down shaft (off)
CAREFUL not to damage gear. must
reinstall gear on new transmission. hammer gear down shaft until gear covers
both holes on output shaft.
2) Mechanical Nylon / Digital Gear set
information converted to digital signal.
To remove the nylon drive gear from
original transmission. Depress metal clip and tap nylon gear towards the rear
of the output shaft.
- Re-install gear the reverse way on
new transmission.
- Install metal clip in the front hole
in output shaft,
- Slip drive gear down shaft until
clip lock gear into place. Install Driven gear and housing into tail housing.
3) Mechanical = Mechanical
Nylon Gear set information set via mechanical cable.
Remove and Install the Gear set as
shown.
Drive Gear = Gear on output shaft
Driven Gear = Gear that is installed
into Tail Housing.
If you have any questions please
contact our Tech Support Team at (800) 708-0087 ext. 2
